These projects will take you less than three hours to complete, cost you very little money, and only need a few simple hand tools. That’s a relatively minor price to pay for a worry-free winter of warm, cost-effective comfort.
Winter is brutal enough without your furnace breaking down or failing to provide enough heat. An ounce of prevention is definitely worth a pound of cure when it comes to furnaces. So, here are some simple maintenance activities recommended by the furnace maintenance humble you can do to guarantee that your natural gas or propane-fueled furnace runs well throughout the winter.
Also, keep an eye out for these winter survival tips to help you get through the season.
Read the 8 Furnace Troubleshooting Tips:
- Step 1
You may avoid having to buy a new furnace by doing routine maintenance. To begin repairing your furnace, turn off the electrical power. Remove the burner cover and the combustion chamber door by raising it and dragging it out (if you have one). Two screws are typically used to hold it in place.
- Step 2
Turn on the electricity and activate the burners by increasing the temperature on your thermostat. Examine the flames of the burner. The fire should be blue and pretty even.
- Step 3
Turn off the power switch and turn the valve a quarter cut to turn off the gas. The furnace burners and the furnace base should be vacuumed. Tape a 20-in. piece of 1/2-in—drain line to your vacuum hose to get to the rear of the burners.
Vacuum everywhere there is dust. While everything is open, check for traces of soot (fine black powder), which indicates poor combustion. Vacuum the blower compartment by removing the bottom door (blower door).
- Step 4
To clean the blower (also known as a squirrel cage), remove it. Two screws will unscrew the control panel in front of the blower, allowing you to hang it. Remove the two bolts that hold the blower in place using a 7/16-in. Socket and ratchet, then carefully pull it out.
- Step 5
Using a vacuum and a tiny brush, carefully clean the blower blades. Take care not to damage the wiring or the counterweights that will be attached to the fan blades. If you can’t clean the blower thoroughly, don’t clean it at all; it may become unbalanced.
- Step 6
Every one to three months, replace the furnace filter. A $1 fiberglass filter will suitably protect the blower and blower motor. Check the owner’s handbook for manufacturer recommendations if you wish to install a more costly, high-efficiency filter. If you have no idea about replacing a furnace filter, you can always book our specialist from heating services humble, TX.
- Step 7
Remove the dust from the pilot by blowing via a drinking straw, directing air to the precise place. The flame sensor (or thermocouple) may be fooled into thinking the pilot isn’t lit if the pilot is filthy. Instead of pilots and electrical igniters, some contemporary furnaces use hot surface igniters.
- Step 8
The flame sensor might get covered with residue over time, making it impossible for your furnace to start. Pull it out of its bracket by dragging it down. Remove the sensor from its mount and lightly wipe the surface with a fine emery cloth. Search furnace repairs humble TX on the internet or visit our official website of JHC Cooling and Heating. You can even call us at (281) 658-4946.